1. 您好,歡迎光臨萊州聚峰機械有限公司官方網站! 鄭重聲明 購機 售后 聚峰官微

            全國咨詢熱線

            400-879-1999

            您的位置: 首頁 > 新聞資訊 > 合作資訊 >
            混凝土攪拌車出車前中科聚峰廠家都有哪些必要檢查呢?
            來源:http://www.mag2vow.com/ 日期:2020-04-06
              1. 確保中科聚峰混凝土攪拌車處于停止狀態,因為如果攪拌車處于高速旋轉狀態,當發動機啟動時,瞬時力將會非常大,這將損壞減速機。
              1. Ensure that zhongkejufeng concrete mixer is in the stop state, because if the mixer is in the high-speed rotation state, when the engine starts, the instantaneous force will be very large, which will damage the reducer.
              2. 確保水箱中有足夠的水,并有可用的減水劑。由于種種原因,這材料太干了。
              2. Make sure there is enough water in the water tank and available water reducing agent. For various reasons, the material is too dry.
              3.自動上料混合機點火前,檢查油、防凍液、潤滑油和冷卻水。如發現不足,應重新補上。
              3. Check oil, antifreeze, lubricating oil and cooling water before ignition of automatic feeding mixer. If any deficiency is found, it shall be made up again.
              4. 還要檢查自動上料攪拌機的燈光,尤其是腰部的燈光,一定要照射在輪胎邊緣,施工現場經常會亂堆放鋼材等東西,而且輪胎一側比較薄弱。
            中科聚峰廠家
              4. Check the light of the automatic feeding mixer, especially the light at the waist, which must be on the edge of the tire. Steel and other things are often stacked randomly on the construction site, and one side of the tire is relatively weak.
              5. 還要用抹布清潔后視鏡和兩邊的玻璃。施工現場情況復雜,光線不好。
              5. Clean the rear-view mirror and the glass on both sides with a rag. The construction site is complex with poor light.
              6. 汽車啟動后,讓汽車以低速旋轉。檢查一下車周圍的胎壓,看看有沒有爆胎.
              6. After the car starts, let the car rotate at a low speed. Check the tire pressure around the car to see if there is a flat tire
              以上就是中科聚峰廠家在中科聚峰混凝土攪拌車發車前一定不要忘記檢查的詳細介紹,想要了解更多請點擊官網http://www.mag2vow.com
              The above is the detailed introduction of the inspection that must not be forgotten before the concrete mixer truck of Zhongke Jufeng is started. For more information, please click the official website http://www.mag2vow.com