1. 您好,歡迎光臨萊州聚峰機械有限公司官方網站! 鄭重聲明 購機 售后 聚峰官微

            全國咨詢熱線

            400-879-1999

            您的位置: 首頁 > 新聞資訊 > 行業新聞 >
            自動上料攪拌機發動機運行錯誤的含義是什么?
            來源:http://www.mag2vow.com/ 日期:2021-07-07
            由于自動上料攪拌機上的某些特定駕駛員不認為發動機溫度低,因此發動機恒溫器將自動移除,而冷卻劑只能從夜間循環中移除。發動機通常在高溫條件下運行,因為無法調節冷卻強度。這會導致磨損并增加燃油消耗。實際上,高溫對發動機有害。為了確保發動機的使用壽命,應將安裝了自動飼料混合器的用例限制在環境溫度范圍內。
            Since some specific drivers on the automatic feeding mixer do not think the engine temperature is low, the engine thermostat will be removed automatically and the coolant can only be removed from the night cycle. Engines are usually operated at high temperatures because the cooling intensity cannot be adjusted. This causes wear and increases fuel consumption. In fact, high temperature is harmful to the engine. In order to ensure the service life of the engine, the use case with automatic feed mixer should be limited to the ambient temperature range.
            我喜歡橡皮筋。如果皮帶太松,皮帶不僅會拉伸和損壞,縮短皮帶的使用壽命,而且過大的壓力會自動加載并扭曲攪拌機的發電機和泵軸,從而損壞中科攪拌機。為了滿足技術要求,必 須松開自動飼料攪拌機的風扇皮帶。建議的組裝偏差為10-15毫米。
            I like rubber bands. If the belt is too loose, the belt will not only stretch and damage, shorten the service life of the belt, but also the excessive pressure will automatically load and twist the generator and pump shaft of the mixer, thus damaging the Zhongke mixer. In order to meet the technical requirements, the fan belt of the automatic feed mixer must be loosened. The recommended assembly deviation is 10-15mm.
                                中科攪拌機
            許多駕駛員知道這輛車才剛剛起步。同樣,如果發動機轉速太低,它也不會打滑并可能損壞發動機。
            Many drivers know that the car is just starting. Similarly, if the engine speed is too low, it will not slip and may damage the engine.
            但是,大多數人都知道,中科攪拌機的油泵由于加熱速度慢而無法在短時間內閑置,因此無法快速潤滑光滑的表面潤滑劑。同時,由于熱燃油霧化不足,燃燒的燃油進入曲軸箱,沖刷氣缸壁上的油膜并加速零件的磨損。因此,在自潤滑發動機啟動后的幾秒鐘的高溫條件下,有必要改善怠速加熱并提高發動機滑移率。
            However, most people know that the oil pump of Zhongke mixer cannot be idle for a short time due to its slow heating speed, so it is unable to quickly lubricate the smooth surface lubricant. At the same time, due to insufficient atomization of hot fuel, the burning fuel enters the crankcase, washes the oil film on the cylinder wall and accelerates the wear of parts. Therefore, it is necessary to improve the idle heating and increase the engine slip rate in the high temperature condition of a few seconds after the start-up of the self-lubricating engine.
            這是自動上料攪拌機中使用的發動機不正確的結果,您了解嗎?
            This is the result of incorrect engine used in automatic feeding mixer, do you understand?